Milling Juniper
A friend who lives up by Taos gave me some juniper last year, and I’ve been slowly milling it into usable lumber (or microlumber). Here are some of the latest pieces, fresh off the saw.
As an idea of how this will age, here’s a bowl that I turned from some similar juniper in December of 2021. Note how the reddish-brown heartwood has darkened, and the whitish sapwood has yellowed a bit. I suspect the stuff I’m currently milling will end up aging similarly.
I’m excited about getting the rest of this juniper milled. I’m aiming for pieces that will finish at least ¼ inch thick (6mm), but no more than ½ inch thick (12mm) so I get a goodly number of finished boards. Most of them will square up between 2 and 3 inches wide (50-75mm), and when I get to pieces smaller than an inch wide (25mm), I generally start milling them into pen blanks.
Discuss...
Reply to this in the fediverse: @davepolaschek@writing.exchange