Milwaukee M18 Circular Saw Box
In my ongoing quest to organize and clean up my shop, I made a box to hold my cordless circular saw and spare blades for it from some pine and plywood. The box was built in two parts, as I didn’t have any pine boards tall enough to make the entire box in one piece and then cut it apart, so the dovetails on the corners look a little strange. The pine is, again, leftovers from my bookcases. The plywood top and bottom are from a neighbor’s garage sale last year, and were free.
I put an insert in the bottom to separate the saw from the spare blades. Nothing fancy, it’s just glued into a pair of dados.
One the bottom was complete, I built the top slightly larger than the same size, then trimmed it to match the bottom. Then glued and screwed on the top and bottom, added a piano hinge and a couple latches, and it’s done. The only snag was that the only screws I had for the piano hinge were ¾ inch long, and the wood I was putting them into was only ½ inch thick, so I cut them flush with a flush-cutting hacksaw and then filed them smooth. And ordered some #6x½ screws.
Discuss...
Reply to this in the fediverse: @davepolaschek@writing.exchange