Fixed Fence Kerfing Plane
Originally written August 20, 2017
Back when I got my Roubo Frame saw kit from Bad Axe Toolworks, I also got the kerfing plane kit. I finally got around to finishing that this morning, and have put it to use.
With the kit you get a saw plate and a cherry board. Step one is cutting a hand-hold in the board. A couple different spade bits, some connect-the-dots with a coping saw, and some smoothing with rasps and files and I had that done.
Next was cutting a rabbet for the fence. Two saw cuts, and a little cleanup with a rabbet plane, and that was done.
Since I'm mostly after ¼ to ⅜ thick stock at the moment, I decided to make my fixed fence with a ⅜” kerf. So I clamped a couple ⅜×3/16 brass bars to the fence, and sawed right next to them with my pull saw. As it's just barely long enough, I had to start the kerf on one end, other, and then bring down the middle until it was level.
Drill a few holes, and put in the saw plate with the provided saw nuts (much easier said than done), and I had a completed kerfing plane, as shown in the first picture. The final picture shows a ½” deep kerf I cut in a poplar board to test things out. Looks pretty good!
Contents
#woodworking #handyTools #tools
Discuss...
Reply to this in the fediverse: @davepolaschek@writing.exchange