Small Storage Solutions
Over the past couple days, I continued to tackle the entropy that is my benchtop. I made these two small and quick storage solutions to try and keep things organized.
First is a caddy to hold my twist drill bits. I use these a lot, and all of the commercial solutions I’ve seen figure you only have one drill bit of each size, which isn’t the reality in my shop. For the smallest size (1/32 inch), I have 15 bits, which leads me to believe I’m on my second dozen, and have broken 9 or so. These bits are pretty fragile, and when drilling pilot holes for small screws in wood, I will sometimes break them.
So I found a piece of canarywood on the shelf and drilled some holes in it. The front row is by 64ths, from 2-16, and the back is 17/64, then the 32nds to 3/8, plus ½. Fairly quick build, as it was just drilling a bunch of holes, but also much-needed.
Next is a small caddy to hold my nut-drivers and a handle I made to use them by hand, rather than with my 1/4” drive cordless drill (though I use that pretty often, too).
The caddy is rock maple. Again, mostly just a bunch of holes, but the spacing was tricky and carving out the recess for the handle took most of a morning using gouges.
Both of these will probably spend most of their time on the top of my bench, but they’ll keep the tools from getting lost in the clutter. And they were nice projects to tackle while I was waiting on parts for another #project.
#woodworking #project #shopFurniture
Discuss...
Reply to this in the fediverse: @davepolaschek@writing.exchange